产品名称：QUAD BILATERAL SWITCH FOR TRANSMISSION OR MULTIPLEXING OF ANALOG OR DIGITAL SIGNALS 四路双向开关传输或模拟或数字信号的复用

产品型号：CC4066

产品特征：

1. 15V DIGITALOR ??7.5V PEAK TO PEAK SWITCHING

2. 125??TYPICAL ON RESISTANCE FOR 15V OPERATION

3. SWITCH ON RESISTANCE MATCHED TO WITHIN 5??TYP. OVER 15V SIGNAL INPUT RANGE

4. ON RESISTANCE FLAT OVER FULL PEAK TO PEAK SIGNAL RANGE

5. HIGH ON/OFF OUTPUT VOLTAGE RATIO :

65dB TYP. at fIS = 10KHz, RL = 10K?

?????????????????????????HIGH DEGREE OF LINEARITY :

< 0.5% DISTORTION TYP. at fIS = 1KHz, VIS = 5 Vpp, VDD - VSS > 10V,

RL = 10K?

7. EXTREMELY LOW OFF SWITCH LEAKAGE RESULTING IN VERY LOW OFFSET CURRENT AND HIGH EFFECTIVE OFF RESISTANCE :

10pA TYP. at VDD - VSS = 10V, Tamb = 25?C

8. EXTREMELY HIGH CONTROL INPUT IMPEDANCE (control circuit isolated from signal circuit 1012??typ.)

9. LOW CROSSTALK BETWEEN SWITCHES :

50dB Typ. at fIS = 0.9MHz, RL = 1K?

?????????????????????????MATCHED CONTROL - INPUT TO SIGNAL OUTPUT CAPACITANCE : REDUCES OUTPUT SIGNAL TRANSIENTS

11. FREQUENCY RESPONSE SWITCH ON : 40MHz (Typ.)

12. QUIESCENT CURRENT SPECIF. UP TO 20V

13. 5V, 10V AND 15V PARAMETRIC RATINGS

14. INPUT LEAKAGE CURRENT:

II = 100nA (MAX) AT VDD = 18V TA = 25?C

15. 100% TESTEDFOR QUIESCENT CURRENT

16. MEETS ALL REQUIREMENTS OF JEDEC JESD13B ” STANDARD SPECIFICATIONS FOR DESCRIPTION OF B SERIES CMOS DEVICES”

产品描述：

The CC4066 is a monolithic integrated circuit fabricated in Metal Oxide Semiconductor

technology available in DIP and SOP packages. The CC4066 is a QUAD BILATERAL SWITCH intended for the transmission or multiplexing of analog or digital signals. It is pin for pin compatible with CC4016 , but exhibits a much lower ON resistance. In addition, the ON resistance is relatively constant over the full input signal range. The CC4066 consists of four independent bilateral switches. A single control signal is required per switch. Both the p and n device in a given switch are biased ON or OFF simultaneously by the control signal. As shown in schematic diagram , the well of the n-channel device on each switch is either tied to the input when the switch is ON or to VSS when the switch is OFF. This configuration eliminates the variation of the switch-transistor threshold voltage with input signal, and thus keeps the ON

resistance low over the full operating signal range. The advantages over single channel switches include peak input signal voltage swings equal to the full supply voltage, and more constant ON impedance over the input signal range. For sample and hold applications, however, the HCF4016B is recommended.

产品封装:DIP